========================================================================== The checksum's (found through sum -r) of the files that you have received (other than this README) are as follows: 38512 1 patchSG0001090 45703 689 patchSG0001090.cadmin_sw 46990 1 patchSG0001090.idb ========================================================================== - 1 - 1. Patch_SG0001090_Release_Note This release note describes patch SG0001090 to IRIX 6.1. 1.1 Supported_Hardware_Platforms This patch contains bug fixes for all platforms. 1.2 Supported_Software_Platforms This patch contains bug fixes for Object System (version 1021572036) on a system running IRIX 6.1. The software cannot be installed on other configurations. 1.3 Bugs_Fixed_by_Patch_SG0001090. This patch contains fixes for the following bugs in IRIX 6.1. Bug numbers from Silicon Graphics bug tracking system are included for reference. o Objectserver security bug (Bug #324141). o Objectserver not keeping in synch with changes to /etc/passwd. 1.4 Subsystems_Included_in_Patch_SG This patch release includes these subsystems: o patchSG0001090.cadmin_sw.objectserver 1.5 Installation_Instructions Because you want to install only the patches for problems you have encountered, patch software is not installed by default. After reading the descriptions of the bugs fixed in this patch (see Section 1.3), determine the patches that meet your specific needs. If, after reading Sections 1.1 and 1.2 of these release notes, you are unsure whether your hardware and software meet the requirements for installing a particular patch, run inst. The inst program does not allow you to install patches that are incompatible with your hardware or software. Patch software is installed like any other Silicon Graphics software product. Follow the instructions in your Software Installation Administrator's Guide to bring up the miniroot - 2 - form of the software installation tools. Follow these steps to select a patch for installation: 1. At the Inst> prompt, type install patchSGxxxxxxx where xxxxxxx is the patch number. 2. Initiate the installation sequence. Type Inst> go 3. You may find that two patches have been marked as incompatible. (The installation tools reject an installation request if an incompatibility is detected.) If this occurs, you must deselect one of the patches. Inst> keep patchSGxxxxxxx where xxxxxxx is the patch number. 4. After completing the installation process, exit the inst program by typing Inst> quit 5. To start running the objectserver software installed by this patch, objectserver needs to be restarted. This can be done by giving the following commands: /etc/init.d/cadmin stop; /etc/init.d/cadmin clean; /etc/init.d/cadmin start 1.6 Patch_Removal_Instructions To remove a patch, use the versions remove command as you would for any other software subsystem. The removal process reinstates the original version of software unless you have specifically removed the patch history from your system. versions remove patchSGxxxxxxx where xxxxxxx is the patch number. To start running the original version of the objectserver software, objectserver needs to be restarted by the stop, clean & start sequence described earlier. - 3 - To keep a patch but increase your disk space, use the versions removehist command to remove the patch history. versions removehist patchSGxxxxxxx where xxxxxxx is the patch number. 1.7 Known_Problems