========================================================================== The checksum's (found through sum -r) of the files that you have received (other than this README) are as follows: 59371 2 patchSG0001678 57535 2 patchSG0001678.idb 34073 467 patchSG0001678.license_eoe_sw ========================================================================== - 1 - 1. Patch_SG0001678_Release_Note This release note describes patch SG0001678 to IRIX 5.3 and 6.2. 1.1 Supported_Hardware_Platforms This patch contains bug fixes for All platforms. 1.2 Supported_Software_Platforms This patch contains bug fixes for the following releases of license_eoe o license_eoe 3.0 (version 1023354620) on IRIX 5.3 o license_eoe 3.0 (version 1233354920) on IRIX 6.2 The software cannot be installed on other configurations. 1.3 Bugs_Fixed_by_Patch_SG0001678 This patch contains fixes for the following bugs in IRIX 5.3, and 6.2. Bug numbers from Silicon Graphics bug tracking system are included for reference. o Bug #447172. Setuid allows non root user to gain root access through manipulation of license log files. o Bug #445613. Setuid allows non root user to gain root access through installation of a license with LM_LICENSE_FILE set. 1.4 Subsystems_Included_in_Patch_SG0001678 This patch release includes these subsystems: o patchSG0001678.license_eoe.sw 1.5 Installation_Instructions Because you want to install only the patches for problems you have encountered, patch software is not installed by default. After reading the descriptions of the bugs fixed in this patch (see Section 1.3), determine the patches that meet your specific needs. - 2 - If, after reading Sections 1.1 and 1.2 of these release notes, you are unsure whether your hardware and software meet the requirements for installing a particular patch, run inst. The inst program does not allow you to install patches that are incompatible with your hardware or software. Patch software is installed like any other Silicon Graphics software product. Follow the instructions in your Software Installation Administrator's Guide to bring up the miniroot form of the software installation tools. Follow these steps to select a patch for installation: 1. At the Inst> prompt, type install patchSGxxxxxxx where xxxxxxx is the patch number. 2. Initiate the installation sequence. Type Inst> go 3. You may find that two patches have been marked as incompatible. (The installation tools reject an installation request if an incompatibility is detected.) If this occurs, you must deselect one of the patches. Inst> keep patchSGxxxxxxx where xxxxxxx is the patch number. 4. After completing the installation process, exit the inst program by typing Inst> quit 1.6 Patch_Removal_Instructions To remove a patch, use the versions remove command as you would for any other software subsystem. The removal process reinstates the original version of software unless you have specifically removed the patch history from your system. versions remove patchSGxxxxxxx - 3 - where xxxxxxx is the patch number. To keep a patch but increase your disk space, use the versions removehist command to remove the patch history. versions removehist patchSGxxxxxxx where xxxxxxx is the patch number. 1.7 Known_Problems